CWSI CP-3500D, Руководство по эксплуатации и установке

Страница: 13 / 79

P/N IM-C35KD Rev. C

2014 Commercial Wireless Systems International, LLC.
13
Section 3 - Installation
3.1 Proper Installation Order
The following steps when performed in the listed order will result in a trouble
free installation:
1. Site Signal Survey
2. Control Panel Installation and Basic Programming
3. Device and Repeater Enrollment and installation
4. Control Panel Site Specific Programming
5. Entire installation test
3.2 Preparing the Installation Site
Prior to the installation of a CP-3500D system a signal survey must be performed by a factory trained
technician or authorized dealer. The signal survey determines the location of the CP-3500D,
repeaters, and initiating device transmitters. Refer to the Signal Survey section of this manual for the
proper method to conduct a signal survey. The completed survey becomes the blueprint layout for the
actual installation. When conducting a survey keep in mind the following limitations for each CP-
3500D installation:
1. Maximum number of devices including repeaters is 1024. This is a limitation of the CP-
3500D.
2. Maximum number of repeaters in an installation is 30. This limitation insures that the UL and
NFPA 10 second alarm requirement is met.
3. Maximum number of devices per repeater or direct to the CP-3500D is 100. A repeater will
automatically reject any devices in excess of 100 units that try to report directly to it. This is only a per
repeater limitation not a system limitation.
During the survey locate A/C repeaters and CP-3500D control panel close to available 120/240 Vac
uninterruptible power. All CP-3500D connections must be installed in conduit. When connecting
primary A/C power always follow:
1- National Fire and Electrical Codes (NFPA 72 and NFPA 70)
2- Local Electrical and Fire Code requirements
3- Local AHJ (Authority Having Jurisdiction) requirements
WARNING: Make sure A/C supply is turned OFF prior to connecting the CP-3500D panel.
3.3 Receiving and Unpacking the Equipment
Upon receiving the equipment, the carton should be inspected for damage, which may have occurred
during shipment. Each package should be checked against the packing slip for completeness.
Differences should be reported to CWSI immediately. If any product is suspected of damage it should
be checked for proper operation or returned to CWSI.
3.4 Installing the CP-3500D
WARNING: This equipment must be professionally installed by factory trained personnel. Use
of an antenna other than listed in the compatibility section of this manual may be harmful to
persons, void FCC or damage the equipment.