Custom Audio Electronics KPM300, Справочник по командам

Страница: 58 / 128

$1D $4C
Printers: KPM300
VeriPrint
, KUBE II
VeriPrint
, KUBE-L
VeriPrint
, TK300II
VeriPrint
[Name]
Set left margin
[Format] ASCII GS L nL nH
Hex 1D 4C nL nH
Decimal 29 76 nL nH
[Range] 0 ≤ nL, nH ≤ 255
[Description] Sets the left margin.
• The left margin is set to [(nL + nH × 256) × (horizontal motion unit)] inches.
Printable area
Left margin Printing area width
[Notes] • This command is enabled only if set at the beginning of the line.
• If the setting exceeds the printable area, the maximum value of the printable area is used.
• If the left printing area width is greater than the printable area, the printing area
width is set at maximum value.
• The horizontal and vertical motion unit are speci fi ed by $1D $50. Changing the horizontal
or vertical motion unit does not affect the current left margin.
• The $1D $50 command can change the horizontal (and vertical) motion unit.
• However, the value cannot be less than the minimum horizontal movement amount and
it must be in even units of the minimum horizontal movement amount.
[Default]
[Reference]
$1D $50, $1D $57
[Example]
$1D $50
Printers: KPM300
VeriPrint
, KUBE II
VeriPrint
, KUBE-L
VeriPrint
, TK300II
VeriPrint
[Name]
Set horizontal and vertical motion units
[Format] ASCII GS P x y
Hex 1D 50 x y
Decimal 29 80 x y
[Range] 0 ≤ x, y ≤ 255
[Description] Sets the horizontal and vertical motion units to 1/x inch and 1/y inch respectively.
When x is set to 0, the default setting value is used.
When y is set to 0, the default setting value is used.
[Notes] • The horizontal direction is perpendicular to the paper feed direction.
• In standard mode, the following commands use x or y, regardless of character rotation
(upside-down or 90° clockwise rotation):
n Commands using x : $1B $20, $1B $24, $1B $5C, $1D $4C, $1D $57.
o Commands using y : $1B $33, $1B $4A.
• This command does not affect the previously speci fi ed values.
• The calculated result from combining this command with others is truncated to the
minimum value of the mechanical pitch or an exact multiple of that value.
[Default] x = 204, y = 408
[Reference] $1B $20, $1B $24, $1B $5C, $1B $33, $1B $4A, $1D $4C, $1D $57
[Example]
ESC/POS™ Emulation
58
Command Reference