Custom Audio Electronics KPM300, Справочник по командам

Страница: 25 / 128

[Description] Turns 90° rotation mode on/off. n is used as follows :
n FUNCTION
0, 48 Turns off 90° rotation mode
1, 49 Turns on 90° rotation mode
[Notes] • When underlined mode is turned on, the printer does not underline 90° rotated charac-
ters. All the same it’s possible select the underline mode.
• Double-width and double-height commands in 90° rotation mode enlarge characters in
the opposite directions from double-height and double-width commands in normal mode.
• This command is not available in Page mode.
• If this command is entered in Page mode, the printer all the same save the setting.
Default] n = 0
[Reference] $1B $21, $1B $2D
[Example]
$1B $5C
Printers: KPM300
VeriPrint
, KUBE II
VeriPrint
, KUBE-L
VeriPrint
, TK300II
VeriPrint
[Name]
Set relative print position
[Format] ASCII ESC \ nL nH
Hex 1B 5C nL nH
Decimal 27 92 nL nH
[Range] 0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Description] Sets the print starting position based on the current position by using the horizontal or-
vertical motion unit.
Sets the distance from the current position to [(nL+ nH × 256) × (horizontal or vertical
motion unit)].
[Notes] • It’s possible to print further on the right margin set for every font. In this case the printing
continues up to the maximum border of the printer mechanism and then begins a new
row.
• Any setting that exceeds the printable area is ignored.
• When the starting position is speci fi ed by n motion units to the right: nL + nH × 256 =
n
• When the starting position is speci fi ed by n motion units to the left (negative direction),
use the complement of 65536: nL + nH × 256 = 65536 – n
• If setting exceeds the printing area width, the left or right margin is set to the default
value.
• The horizontal and vertical motion unit are speci fi ed by $1D $50.
• $1D $50 can change the horizontal (and vertical) motion units. However, the value can-
not be less than the minimum horizontal movement amount.
• In standard mode, the horizontal motion unit is used.
• Setting the right value, it’s possible to print characters over the right edge.
[Default]
[Reference]
$1B $24, $1D $50
[Example]
ESC/POS™ Emulation
Command Reference
25