Custom Audio Electronics KPM300, Справочник по командам

Страница: 18 / 128

$1B $28 $76
Printers: KPM300
VeriPrint
, KUBE II
VeriPrint
, KUBE-L
VeriPrint
, TK300II
VeriPrint
[Name]
Set relative vertical print position
[Format] ASCII ESC ( v nL nH
Hex 1B 28 76 nL nH
Decimal 27 10 118 nL nH
[Range] 0 ≤ nL ≤ 255
0 ≤ nH ≤ 255
[Description] Sets the print vertical position based on the current position by using the horizontal or
vertical motion unit. This command sets the distance from the current position to [(
nL
+
nH
× 256) × (horizontal or vertical motion unit)].
[Notes] • When the starting position is speci fi ed by N motion unit to the bottom:
nL
+
nH
× 256 = N
• When the starting position is speci fi ed by N motion unit to the top (negative direction),
use the complement of 65536:
nL
+
nH
× 256 = 65536 - N
• The horizontal and vertical motion unit are speci fi ed by $1D $50.
• The $1D $50 command can change the horizontal (and vertical) motion unit. However,
the value cannot be less than the minimum horizontal movement amount.
• In standard mode, the vertical motion unit is used.
[Default]
[Reference] $1D
$50
[Example]
$1B $2A
Printers: KPM300
VeriPrint
, KUBE II
VeriPrint
, KUBE-L
VeriPrint
, TK300II
VeriPrint
[Name]
Select bit image mode
[Format] ASCII ESC * m nL nH d1...dk
Hex 1B 2A m nL nH d1...dk
Decimal 27 42 m nL nH d1...dk
[Range] m = 0, 1, 32, 33
0 ≤ nL ≤ 255
0 ≤ nH ≤ 3
0 ≤ d ≤ 255
[Description] Selects a bit image mode using m for the number of dots speci fi ed by nL and nH, as fol-
lows:
m MODE
VERTICAL
DIRECTION
HORIZONTAL
DIRECTION (*1)
N° dots DPI DPI N° of data (k)
0 8 dot single density 8 67 100 nL + nH × 256
1 8 dot double density 8 67 200 nL + nH × 256
32 24 dot single density 24 200 100 (nL + nH × 256) × 3
33 24 dot double density 24 200 200 (nL + nH × 256) × 3
[Notes] • The nL and nH commands indicate the number of dots of the bit image in the horizontal
direction. The number of dots is calculated using: nL + nH x 256.
• If the bit image data input exceeds the number of dots to be printed on a line, the excess
data is ignored.
• d indicates the bit image data. Set a corresponding bit to 1 to print a dot, or to 0 to not
print the dot.
• If the value of m is outside the speci fi ed range, nL and data following it are processed
as normal data.
ESC/POS™ Emulation
18
Command Reference