CTE B-LIFT PRO Series, Инструкция по эксплуатации и техническому обслуживанию, Страница: 103 / 148

I n s t r u c t i o n s f o r U s e
a n d M a i n t e n a n c e
Section G
3
Cause
Vehicle tilted more than
maximum slope allowed
Uncalibrated or dirty
distributor valves
Malfunctioning slewing gear
Lack of lubrication
Dirty block valves
Worn cylinder seals
Emergency stop button is
pressed
Waste inside.
Faulty solenoid
Faulty fuse
Problem
The machine does not rotate
correctly.
Creaking of joints and
bushings
Stabiliser cylinder seal failure
The levers do not control any
movement
solenoid valves are blocked
no voltage
Solution
Stabilise the vehicle within the
tolerance permitted
Calibrate or clean the valves
Replace the slewing gear
Grease the joints or bushings
Clean or replace the valve
Replace the seals
Rotate the button until it reaches
normal position.
Operate the solenoid valve cursor
to try unblock it and contact a
specialised workshop.
Replace solenoid
Replace fuse
Repair to be carried out in an authorised CTE workshop