CTC Union GSi 16, Руководство по установке и обслуживанию

Страница: 47 / 120

47 CTC GSi 16
L1
L2
L3
1
2
3
4
Valve bedrock (Y31)
230 V 1N~
Diverting valve Y31 is connected with pump G31 at the following terminal
blocks:
Expansion card (A3) X6:
Control voltage: black Terminal block X6:8
Phase: brown Terminal block X6:9
Zero: blue Terminal block X6:11
From electricity
distribution board
Current sensor
Fuse panel
Connect to G37–G40 on the sensor terminal
block. Use at least a 0.5 mm
2
cable.
8.12 Current sensor connection
(accessory)
The current sensors are connected at G37–G40 on the sensor terminal
block.
The three current sensors, one for each phase, are fitted on the fuse panel.
Each phase from the electricity distribution board supplying the product
is channelled through a current sensor before termination at the relevant
terminal. This allows the phase current to be sensed all the time and
compared with the value set for the heat pump’s load switch. If the current
is higher, the control unit drops to a lower heat output on the immersion
heater. If this is insufficient, the heat pump is also limited. When the power
drops back below the set value, the heat pump and immersion heater are
reconnected. This means that the current sensors, along with the electronics,
prevent more power being supplied than the main fuses can tolerate.
The current sensors’ cable holes are 11 mm in diameter.
The current sensor connection has no alarm, but the current value can be
read in the Operation data menu. Note that the tolerance/accuracy is very
low with small current values.