CTC Union GSi 16, Руководство по установке и обслуживанию

Страница: 101 / 120

101
CTC GSi 16
Heating circuit
Max primary flow ºC 60
Min primary flow ºC Off
Heating, mode Auto
Heating, mode, ext
Heating off, out ºC 18
Heating off, time 120
Inclination ºC 50
Adjustment ºC 0
Night reduction disable ºC -14
Room temp reduced ºC -2
or
Primary flow reduced ºC -3
Alarm room temp ºC 5
Smart low price ºC 1
Smart over capacity ºC 2
Max time heating 20
Charge pump % 60
Drying period mode Off
Drying period temp ºC 25
Example in which “Heating mode” is normally “On” in the
heating season, but when terminal block K24 is closed, “Off”
is activated and the heating is switched off.
Activate/select function.
When an input is assigned, the function must be activated
or set in the Installer/Settings/Heating Circuit
menu.
Normal mode can be defined here (arrow 1).
Here, the normal mode has been selected as:
Heating mode: On
When this is done, you programme what is to happen at /
Remote Control/Heating, external mode HS1 (closed input,
arrow 2).
Arrow 2 indicates the selection "Off".
In this example the heating is always on. (Normal mode).
However, when terminal block K24 is closed, “Off” is
activated and the heating is switched off. The heating
remains switched off until you choose to start heating up by
opening K24.
The functions in remote control.
Tariff HP
When electricity suppliers use a differentiated tariff, you
have the opportunity to block the heat pump when the
electricity tariff is high.
Tariff EL
Open terminal block = "On" (in this example)
Closed terminal block = “Off” (in this example)
K24
K24
i
NB: If both the heat pump and the
immersion heater are blocked, the
building may be without heating
for a long time. It is therefore
recommended that you only block
the immersion heater with the tariff.
1
2