CRUISING ELECTRONICS E-Meter, Руководство пользователя

Страница: 21 / 56

21
The first time you use Your Meter, it assumes you have 200 Amp-hour lead acid
batteries. If your battery capacity is different you must change the declared
battery capacity. Follow these instructions to declare a new capacity:
1) Press and hold the
SET
button for 3 seconds to enter SET UP (and Ad-
vanced Functions) menu.
SEL
appears in the display. Press
SEL
and notice that
the green LED is on.
2) Press
SEL
again and note that the light comes on. Press again and
now the LED is on and 200 appears in the display. This is the default
battery capacity.
3) Now press and hold the
SET
button to scroll through battery size options.
The display will show 1 Amp-hour increments from 20-40 Amp-hours of ca-
pacity, 5 Amp-hour steps from 40-100 Amp-hours capacity and 20 Amp-hour
steps over 100 Amp-hours of capacity. If you continue to hold
SET
, after 4
increments the display scrolls faster. When the value you want appears, release
the
SET button. If you overshoot your capacity you will have to scroll all the
way to 1980 Ahrs after which the display will roll over and begin scrolling up
starting from 10 Amp-hours. NOTE: Versions of Your Meter prior to serial
number 05000 increment only in 20 Amp-hour steps from 20 - 1980 Amp-
hours .
4) After 10 seconds the meter exits the Set Up mode and the selected value is
stored as the new battery capacity and the display returns to (Volts).
Tip:
All SET UP and ADVANCED FUNCTIONS begin with the
SET
button.
SET UP is normally done at installation. The
SET
button may be
LOCK
ed to
prevent unauthorized personnel from tampering with the
SET
functions. See
"LOCK" on Page 32.
Setting Battery Capacity