-
Page 18 -
will now be set to zero (0)
E.
To leave the menu
without
saving
the new value press SW2. To leave the menu
and save
the
value, keep RIGHT BUTTON (SW2) pressed while pressing LEFT BUTTON (SW1).
F.
Press LEFT BUTTON (SW1) several times until the display shows [L], press three more time on
SW1 to exit from service menu.
Alternatively press LEFT BUTTON SW1 continuously for 2sec. to exit from service menu.
G.
The display now goes back to normal operation showing the state of the leveller, shelter or the
door.
2.2.4
Reset the number of cycles counter
A.
The display shows the state of the leveller, shelter or the door.
B.
Press LEFT BUTTON SW1, menu [L] is showed. Enter Leveller submenu by RIGHT BUTTON
SW2 L01 is showed.
C.
Press SW1 several times until submenu L02 is showed. Enter the submenu by RIGHT BUTTON
SW2. The display now shows the number of cycles that is stored (for example “99”).
D.
Press the LEFT BUTTON (SW1) to reset the counter. The previous shown value will now be set
to zero (0).
E.
To leave the menu
without
saving
the new value press SW2. To leave the menu
and save
the
value, keep RIGHT BUTTON (SW2) pressed while pressing LEFT BUTTON (SW1).
F.
Press LEFT BUTTON (SW1) several times until the display shows [L], press three more time on
SW1 to exit from service menu.
Alternatively press LEFT BUTTON SW1 continuously for 2sec. to exit from service menu.
G.
The display now goes back to normal operation showing the state of the leveller, shelter or the
door.
2.2.5
Total service reset (leveller and door):
Resets all error lists
(leveller and door)
and
all service counters
(time and cycles for leveller and door).
H.
The display shows the state of the leveller, shelter or the door.
I.
Press LEFT BUTTON SW1, menu [L] is showed. Enter Leveller submenu by RIGHT BUTTON
SW2 L01 is showed.
J.
Press SW1 several times until submenu L20 (see Table 1) is showed. Enter the submenu by
RIGHT BUTTON SW2, the display now shows U00.
K.
Press the LEFT BUTTON (SW1) and the display shows U01.
L.
To leave the menu
without
saving
the new value press SW2. To leave the menu
and save
the
value, keep RIGHT BUTTON (SW2) pressed while pressing LEFT BUTTON (SW1).
M.
Press LEFT BUTTON (SW1) several times until the display shows [L], press three more time on
SW1 to exit from service menu.
Alternatively press LEFT BUTTON SW1 continuously for 2sec. to exit from service menu.
N.
The display now goes back to normal operation showing the state of the leveller, shelter or the
door.
2.3
Indication of active errors in order of priority
If an error on the leveller occurs, this is normally indicated by showing the error code on the
display.
The error codes for leveller is as follow:
F01: Over current L1.
F02: Over current L2.
F03: Over current L3.
