Cranesmart Systems LMI System, Руководство пользователя

Страница: 27 / 101

26 Cranesmart LMI Version R9
Boom Angle Transducer Installation
The Boom Angle transducer must be installed on the boom at a distance of at least five (5) feet from where the antenna
will be mounted on the cab of the crane (See page 47) and must maintain line of sight with the antenna in all boom
positions. The transducer can be mounted on either side of the boom. The transducer cannot be installed on the top or
bottom of the boom and must be installed in the orientation shown in the diagram below. Do not weld permanently
before testing in case adjustments are needed.
To Install the Transducer:
1. Remove the weld plate from the Angle transducer.
2. Align and mark the installation position. Use the illustration on the transducer label to position the transducer parallel (level) with the boom
line.
3. Tack weld the weld plate before testing the system.
4. Mount the transducer to the weld plate.
5. Raise the boom to a minimum of 45
o
angle and return it to level. (This will set the transducer for the proper side of the boom before
calibration).