page 3
ON
OFF
ON
OFF
4. Hanging Bracket Installation.
3. Installation Preparation.
blade edge
(76cm)
30
inches
7 feet
(2.13m)
Vaulted ceiling
angle is not to
exceed 20 degrees.
downrod
installation
flushmount
installation
Turn off circuit breakers to current fixture from breaker
panel and be sure operating light switch is turned to
the OFF position.
WARNING:
Failure to disconnect power supply prior to
installation may result in serious injury.
Remove existing fixture.
WARNING:
When using an existing outlet box, be sure the
outlet box is securely attached to the building structure
and can support the full weight of the fan. Ensure the
outlet box is clearly marked "Suitable for Fan Support." If
not, it must be replaced with an approved outlet box.
Failure to do so can result in serious injury.
CAUTION
:
Be sure outlet box is grounded properly and
that a ground wire (
GREEN
or bare) is present.
Install hanging bracket to outlet box using original
screws, spring washers and flat washers provided with
new or original outlet box.
*
If installing on a vaulted
ceiling, face opening of hanging bracket towards high
point of ceiling. Arrange electrical wiring around the
back of the hanging bracket and away from the
hanging bracket opening.
*Note
: It is very important that you use the proper
hardware when installing the hanging bracket as this will
support the fan.
12f
t.
- 20f
t.
12ft. - 20ft.
(3.66m - 6.1m)
(3.66m - 6.1m)
To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 7ft. (2.13m) from the floor and 30in.
(76cm) from any wall or obstruction.
This fan is suitable for room sizes up to 400
square feet (37.2 square meters).
This fan can be mounted with a
downrod
on a regular (no-slope) or vaulted ceiling. The
hanging length can be extended by purchasing
a longer downrod (0.5in./1.27cm diameter).
After
installing hanging bracket,
c
ontinue to Section 5
on page 4 for those instructions.
This fan can also
be mounted with
flushmount
installation
only
on a regular (no-slope) ceiling.
After installing
hanging bracket, continue to Section 6 on page 5
for those instructions.
Installation requires these tools:
Phillips screwdriver, flat-head screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.
hanging bracket
spring washers
outlet box screws
flat washers
