COSMOGAS MYDENS 60, Инструкция по установке, эксплуатации и обслуживанию

Страница: 38 / 72

38
MYDENS 60
COSMOGAS
Figure 6.15 - Corresponding values to introduce
into the parameter
2002 to obtain the desired
power necessary in central heating mode
6 - OPERATING
Power necessary
(kW)
Values for
parameter
2002
60 100
59 98
57 94
55 90
53 86
51 83
49 79
47 75
45 71
43 68
41 64
39 60
37 56
35 53
33 49
31 45
29 41
27 38
25 34
23 30
21 26
19 23
17 19
15 15
13 11
11 8
9 4
7,5 1
ATTENTION !!! If during forcing, the power
supplied by the boiler is much higher than the
power absorbed by the plant, the boiler switches off
continuously to reach the maximum temperature
allowed (93°C). To remedy this problem the heating
power must be set at the effective plant requirement, as
laid down in chapter 6.9 and the CO2 analysis test or
combustion efficiency test must be carried out, setting
parameter
2010
previously referred to at the
rEg
value.
6.9 - Adjustment of the power in
central heating mode (Range Rated)
This appliance is designed and type-approved to adapt the
maximum heating power to the effective necessity of the plant
as per calculation. To do this and to use the boiler’s potentiality
to its best, it is recommended to set the maximum power in
central heating mode at the effective requirement of the plant.
Operate as follows:
1.- press the
and RESET keys simultaneously
for more than 5 seconds to enter the “installer” menu,
confirmed by the appearance of the icon on the
display.
4.- using the and keys, access the
parameter
2002
;
5.- press the RESET key to enter the parameter and using the
and keys modify the value corresponding
to the power required by the plant, according to the table
in Figure 6.15.
6.- Press the RESET key to confirm the modification.
7.- Hold the RESET key down for 5 seconds to exit the
“installer” menu.