COSMOGAS AGUAPLUS 100, Инструкция по установке, эксплуатации и обслуживанию

Страница: 21 / 80

21
AGUAPLUS
COSMOGAS
Figure 6-2 - Install leveling feet
Figure 6-1 - Lifting system
6 - INSTALLATION - Setup
6.1 - Setup
To install the appliance correctly and easily, the following steps
must be scrupulously followed.
6.1.1 - Moving the appliance
WARNING !!! Always lift and carry the appliance
with a lift truck or special equipment. Failure to comply
with this provisions could result in sever personal
injury, death or substantial property damage.
Position the appliance in the area selected for installation,
moving it using the pallet it is fixed to, taking care to keep
it vertical without making any sharp movements that might
cause it to overturn.
Proceed as follows to remove the appliance from the pallet
(see Figure 5-1):
1.- Remove front cover “A” and bottom front cover “B” (see
section 15.2);
2.- Remove panel “D” by loosening screws “E” to access
screws “C”;
3.- Unscrew the front clamping screws (part “C”) and rear
clamping screws (detail “F”);
4.- Remove the rear fixing brackets (G);
5.- Reassemble front cover “A” and “B”.
6.1.2 - Opening the package
The appliance is supplied in cardboard package, fixed to the
pallet for transportation. Be careful when opening it, take the
cardboard box off by lifting it upwards, after detached it from
the pallet.
6.1.3 - Lifting the appliance
There is a bracket (detail“A” in Figure 6-1) to facilitate
installation that allows the appliance to be lifted.

Remove the top cover as per section 15.2.

Hook lifting cables “B” to the bracket “A” in Figure 6-1, and
lift the appliance.
WARNING !!! The cables and lifting system must
be suitable for the purpose envisaged. In particular, they
must be able to bear the weight of the appliance (section
16).

Install the leveling feet “A” to level the appliance as shown
in Figure 6-2.
Once the appliance has been positioned properly, the lifting
cables (detail “B” in Figure 6-1) must be removed before
applying the top cover.
A
A
020010.01.013
B
MIN 0
MAX 0,39 " (10 mm)
020010_01_030
B = Locking nut
AA
020021.01.009
B
A
020021.01.010
MIN
1 m