Corghi Artiglio Master 26 MI, Руководство оператора

Страница: 51 / 212

Artiglio Master
operator’s manual 51
EN
WARNING
For technical characteristics, warning notices, maintenance and all other information
regarding the air tank, refer to the air tank operator’s manual supplied with the ma-
chine documentation.
Controls
Display for setting and displaying the wheel data - fig. 9a
1 - Air pressure gauge
Pressure gauge which displays the air pressure set with the pedal 3 fig.9c.
Displays the tyre pressure in bar.
2 - Wheel type selection panel
Arrow-shaped keys allowing the tyre changer to be set to accept parameters relating to
two categories of wheel: conventional car, off-road vehicle or van wheel or PAX wheel.
3 - Rim diameter display.
Display for showing the rim diameter in inches. The figure displayed consists of two
figures separated by a decimal point.
4 - Rim diameter setting keypad
The keypad subdivides into:
- keys for entering the numerical values of the units. Use these keys to enter the value
of the units by increasing (+) or decreasing (-) the value set;
- keys for entering the numerical values of the decimal figures. Use these keys to enter
the value of the decimal figures by increasing (+) or decreasing (-) the value set;
5 - Deflation button
Press this button to discharge excess air from inside the tyre. This button can only be
used during inflation of the tyre with the Doyfe union of the inflation line connected to
the stem of the valve.
Master switch-fig.9d
1 - Master switch
Green two-position on the lid of the electrical box (1 fig.9d).
On “0” - the machine is not receiving mains power.
On “1” - the machine is powered up. Control console - fig. 9b
Control console - fig. 9b
Area A - Bead breaker disc unit functional controls
1 - Lever controlling vertical movement of the top bead breaker disc.
2 - Lever controlling vertical movement of the bottom bead breaker disc.
3 - Button without detent controlling forward movement of the top bead breaker disc.
When the top bead breaker disc is resting on the tyre, pressing this button moves the disc
forward in a radial direction, so that it enters the wheel following the profile of the rim.
Area B - Tool head functional controls
4 - Button controlling head rotation
Press the Button to rotate the tool head through 180°. This control allows selec-
tion of the tool suitable for mounting or demounting the tyre. The control is only