D2 W MDME 2400 Wireless Ethernet Modem
IF 1584 Rev. 1
IF 1584 Rev. 1
Page 60
Connecting Two Separate Networks Together
Network A Configuration.
In this example, Network A is connected to the Internet via a router at IP address 192.168.0.1.
Devices on Network A that only require access to devices on Networks A and B should have their
gateway IP address set to the D2 W MDME 2400 Access Point as 192.168.0.200.
Devices on Network A that must interact with devices on Networks A and B and the Internet should
set the Internet router 192.168.0.1 as their gateway, and must have a routing rule established for
devices on Network B. On PCs, this may be achieved with the MS-DOS command ROUTE. For
this example, use: ROUTE ADD 169.254.102.0 MASK 255.255.255.0 192.168.0.200.
Network B Configuration.
All devices on Network B should be configured so their gateway IP address is that of the D2 W
MDME 2400 Access Point as 169.254.102.54.
Access Point Configuration
•
Connect straight-through Ethernet cable between PC and D2 W MDME 2400.
•
Ensure configuration PC and D2 W MDME 2400 are set up to communicate on the same
network.
•
Set dip switch to SETUP.
•
Power up unit, and wait for LINK LED to cease flashing.
•
Adjust PC network settings.
Set Configuration PC network card with network setting of IP address 192.168.0.1, netmask
255.255.255.0.
•
Open configuration web page with Internet Explorer at address http://192.168.0.1XX/.
When prompted for password, enter default username “user” and password “user.”
Enter “Network,” and select Operating Mode as Access Point.
Device Mode should be set to Router.
Set the Gateway IP address to 192.168.0.1.
Set the Ethernet IP address to 192.168.0.200, network mask 255.255.255.0.
Set the Wireless IP address to 169.254.102.54, network mask 255.255.255.0.
LAN A
Internet
Client
Bridge
Access Point
Router
192.168.0.200
255.255.255.0
LAN B
169.254.102.53
255.255.255.0
169.254.102.53
169.254.102.54
