D2 W MDME 2400 Wireless Ethernet Modem
IF 1584 Rev. 1
IF 1584 Rev. 1
Page 26
After changes are made to Network Configuration, it is important to save the configuration by
selecting “Save and Reset.”
Network Settings Web Page Fields.
Operating Mode
Used to select Access Point (Infrastructure), Client (Infrastructure), IBSS
(Ad-Hoc), or MONITOR mode. By default, this is set to Client.
Device Mode
Used to select Bridge or Router mode. By default, this is set to Bridge.
FTP Enabled
This enables access to volatile memory storage on the D2 W MDME
2400. By default, this is disabled.
MAC Address
This is the unique hardware address of the D2 W MDME 2400 assigned
in the factory. For the majority of systems, this item should not be
changed. If the device is to be connected to equipment that will only
communicate with a set MAC Address, the D2 W MDME 2400 may
clone that MAC address.
Gateway IP
Address
This is only required if the wired LAN has a gateway unit which connects
to devices beyond the LAN - for example, Internet access. If there is no
gateway on the LAN, set to the same address as the Access Point - that is,
the “Ethernet IP Address” below.
Ethernet IP
Address
The IP address of the D2 W MDME 2400 on its wired Ethernet port. This
should be set to the IP address you require.
Ethernet IP Subnet
Mask
The IP network mask of the D2 W MDME 2400 on its Ethernet port.
This should be set to the IP address you require.
Wireless IP
Address
The IP address of the D2 W MDME 2400 on the wireless port. If the unit
is configured as a Bridge, this address will be the same as the Ethernet IP
address. If configured as a Router, the IP address must be different from
the Ethernet IP Address - it must be consistent with the LAN it is
connecting to on the wired side.
Wireless IP
Subnet Mask
The network mask of the D2 W MDME 2400 on the radio port. If
configured as a Bridge, this must be the same as the Ethernet IP Subnet
Mask.
System Address
(SSID)
A D2 W MDME 2400 network comprises modules with the same "system
address.” Only modules with the same system address will communicate
with each other. The system address is a text string 1 to 31 characters in
length. Select a text string which identifies for your system.
Desired BSSID
To force a client/station to always connect to the same Access Point, enter
the MAC address of that Access Point in the desired BSSID field (Note
that the SSID of the Access Point must also match the configured SSID of
the client).
Radio Encryption
Select “None,” “WEP (64-bit),” “WEP (128-bit),” “WPA-PSK (TKIP),”
or “WPA-PSK (AES)” security encryption of the wireless data. The
default setting is “None.”
Encryption Keys 1 These are the keys used to encrypt radio data to protect data from
