Chapter Three
Operation
Page 21 November
2008
•
Set the factory default switch to the
SETUP position. This will always
start the D2 W MDME 2400 with
Ethernet IP address 192.168.0.1XX,
subnet mask 255.255.255.0, gateway
IP 192.168.0.1, and the radio
disabled.
Do not forget
to set the
switch back to the RUN position and
cycle power at the conclusion of
configuration for resumption of
normal operation.
•
Power up the D2 W MDME 2400
module.
•
Open “Network Settings” on your PC
under Control Panel. The following
description is for Windows XP -
earlier Windows operating systems
have similar settings.
•
Open “Properties” of Local Area
Connection.
•
Select Internet Protocol (TCP/IP)
and click on Properties.
•
On the General tab, enter IP address
192.168.0.1, Subnet mask 255.255.255.0, and default gateway 192.168.0.1.
