CONVEY-ALL BTS-295, Руководство оператора, Страница: 44 / 59

Operator’s Manual: Bean Tender-Swing Conveyor (BTS)
4-8 08.2015
Fig 64 - Roller bearing anchor bolts, guard removed
Fig 65 - Tension bolts, below engine
4.3.2 Conveyor Belt Alignment:
The belt is properly aligned when it runs in the centre
of the rollers on both ends.
As with tensioning, the alignment should be checked
weekly, or as required.
1. Rotate the conveyor belt one revolution when the
belt is new. Check it’s position on the drive and
discharge rollers.
Note:
If belt is out of alignment,
it will move to the loose side.
Tighten loose side or loosen tight side.
2. Loosen the drive roller bearing housing anchor
bolts.
3. Use the tension bolts to set the position.
4. Rotate the belt another revolution and check the
alignment. Adjust as needed.
Check frequently during the first few minutes of
operating with a new belt and then several times
during the first 10 hours.
The belt normally seats itself during the first 10 hours
of operation and can be checked weekly after that.