CONVEY-ALL BTS-295, Руководство оператора, Страница: 43 / 59

Operator’s Manual: Bean Tender-Swing Conveyor (BTS)
08.2015 4-7
Fig 62 - Roller bearing housing, with guard
Fig 63 - Tension bolts, below engine
4.3 MAINTENANCE PROCEDURES
By following a careful service and maintenance
program for your tender, you will enjoy many years of
trouble-free service.
Note:
Refer to the engine manual for complete
details on your particular model.
4.3.1 Conveyor Belt Tension:
WARNING: Rotating Part Hazard
Turn off engine and wait for all belts to
stop rotating.
Belt tension is pre-set at the factory, under no
load. Check the tension often while breaking-in the
conveyor, because the belt may stretch.
The conveyor belt should not slip on the hopper and
discharge rollers during operation.
The tension of the belt should be checked daily, or
more often if required, to be sure that it does not slip
under load.
To maintain the belt, follow this procedure:
1. Loosen the hopper roller bearing on both sides.
2. Adjust both tension bolts to set the tension of
the belt.
3. Tighten bearing housings.
Note:
If belt needs more, or less slack,
stop belt, and turn off engine.
Move hopper roller 1/4 to 1/2 inch.
Tension the belt.
IMPORTANT:
If tensioning the belt while it is running,
Adjust in small incriminates,
alternating between the two bolts often.
This will keep the belt aligned.