CONVEY-ALL BTS-295, Руководство оператора, Страница: 32 / 59

Operator’s Manual: Bean Tender-Swing Conveyor (BTS)
3-14 08.2015
3.6.1 Stopping Conveyor:
1. Run until conveyor belt is empty.
2. Reduce speed to low idle.
3. Move engine assembly to disengage drive belt.
4. Shut off engine
3.6.2 Emergency Stopping:
Although it is recommended that the conveyor belt be
emptied before stopping, in an emergency situation,
stop or shut-down the power source immediately.
Correct the emergency before resuming work.
3.6.3 Restarting after Emergency Stop:
When the machine is shut down inadvertently or in
an emergency, the conveyor belt will still be covered
with material.
Since the start-up torque loads are much higher than
normal when the belt is covered. Restart at a low
speed. It may be necessary to tighten the drive belt
slightly to handle the heavier than normal loads.
3.6.4 Unplugging:
If conveyor becomes plugged, follow this procedure:
1. Stop engine and remove ignition key.
2. Remove the 3-Stage Downspout.
3. Remove product from the discharge spout.
4. Close the compartment gate.
5. Remove any obstruction from between the gate
and conveyor.
6. Reattach the 3-Stage Downspout.
7. Restart engine.
If the conveyor belt is full, torque loads will be
much higher than normal. Restart at a low speed.
It may be necessary to tighten the drive belt
slightly to handle heavier than normal loads.
Fig 42 - Discharge spout
Fig 43 - Hopper gate and conveyor