CONVEY-ALL BTS-295, Руководство оператора, Страница: 14 / 59

Operator’s Manual: Bean Tender-Swing Conveyor (BTS)
2-6 Revised 02.2019
2.7 MAINTENANCE SAFETY
• Review the Section 4: Service and Maintenance
of this Manual before working with, maintaining or
operating the conveyor.
• Follow good shop practices:
- Keep service area clean and dry.
- Be sure electrical outlets and tools
are properly grounded.
- Use adequate light for the job.
• Place all controls in neutral or off, stop the engine
and remove ignition key. Wait for all moving parts
to stop before servicing, adjusting, unplugging or
repairing.
• Keep hands, feet, hair and clothing
away from all moving and/or rotating
parts.
• Replace parts with genuine factory replacements
parts to restore your equipment to original
specifications.
Convey-All Industries Inc. will not be responsible
for injuries or damages caused by the use of
unapproved parts and/or accessories.
• Make sure there is plenty of ventilation. Never
operate the engine in a closed building. The
exhaust fumes may cause asphyxiation.
• Clear the area of bystanders, especially children,
when carrying out any maintenance and repairs or
making any adjustments.
• Before resuming work, install and secure all guards
when maintenance work is completed.
• Keep safety decals clean. Replace any decal that
is damaged or not clearly visible.
2.8 OPERATING SAFETY
• Be sure that anyone who will be
operating the machine or working on or
around the unit reads and understands
the operating, maintenance and safety
information in this operator’s manual.
Review the manual annually.
• Clean and replace all safety decals if they cannot
be clearly read and understood.
• Place all controls in neutral, stop the engine.
Remove the ignition key. Wait for all moving parts
to stop before servicing, repairing or unplugging.
• Keep all bystanders, especially children, away
from the machine when loading or unloading. Only
authorized personnel should be in the work area.
• Establish a lock-out tag-out policy for the work
site. Be sure all personnel are trained in and follow
these procedures.
Lock-out tag-out all power sources before
servicing the unit or working around accompanying
equipment.
• Be familiar with machine hazard area. If anyone
enters hazard areas, shut down machine
immediately. Clear the area before restarting.
• Do not place hands, arms or body
between moving parts to prevent
pinching or crushing. Components can
move unexpectedly.
• Keep hands, feet, hair and clothing
away from all moving and/or rotating
parts.
• Do not allow riders on the tender.
• Keep working area clean and free of debris to
prevent slipping or tripping.
• Stay away from overhead obstructions
and power lines during operation and
transporting. Electrocution can occur
without direct contact.
• Do not operate machine when any guards are
removed.