CONVEY-ALL 1635-FL, Руководство оператора

Страница: 41 / 60

08.2020 4-7
Operator’s Manual: 1600-FL Series Conveyor
Fig 44 - Gas engine
Fig 45 - Side PTO
Fig 46 - Upper lift bearings
Fig 47 - Clean conveyor
4.2.4 After 200 hours or Annually:
Gas Engine Units:
22. Refer to the engine manual for specific
service and maintenance schedules.
23. Change engine oil and filter.
24. Change engine air filter.
PTO Drive Units:
Change the oil in the PTO gearbox.
All conveyors:
25. If equipped with a battery, test its charge.
- It should retains its maximum charge.
26. Grease the upper lift bearings.
27. Check that the tube is straight.
- Side to side and end to end.
- If adjustment is necessary, take tension off
cables by supporting the tube.
Note:
Feed a thin strap between the tube
and windguard, around bottom
of tube and out the other side.
Then, support tube by winch/forklift.
- Adjust eyebolts at the hopper end.
- Remove support from the tube to view the
result of the adjustment.
- Repeat process until the tube is straight.
28. Repack the wheel bearings.
29. Wash the entire machine thoroughly to
remove all dirt, mud, debris or residue.
- Wash the outside.
- Wash around the hopper.
- Leave the belt running while washing
inside the tube and around the belt.