CONVEY-ALL 1635-FL, Руководство оператора

Страница: 39 / 60

08.2020 4-5
Operator’s Manual: 1600-FL Series Conveyor
Fig 37 - Hopper roller bearing
Fig 39 - Top-end electric drive
Fig 38 - Hopper flashing
4.2.2 After 50 Hours or Weekly:
11. Check the conveyor belt tension.
Watch the tension more often while
breaking-in the conveyor, because the belt
may stretch. Refer to Section 4.3.1
12. Check the conveyor belt alignment.
- How the belt is aligned to the rollers must
be checked at the hopper, transition, at the
drive box and the discharge.
Watch the alignment more frequently during
the first 10 hours of operation. It usually
seats itself and can be checked weekly after
that. Refer to Section 4.3.2
13. Check the condition of the rubber, hopper
flashing. Be sure it still seals the hopper to
prevent leaking.
If any product comes out of the hopper
around the flashing, loosen flashing mounting
screws and adjust. Retighten anchor screws
and try running the conveyor again. Repeat
until no grain is lost.
If the flashing is stuck to the belt, manually
peel the flashing up and off the hopper.
Replace it if necessary.
Gas or Electric Units:
14. Check drive belt tension.
Refer to Section 4.3.4
15. Check drive pulley alignment.
Refer to Section 4.3.5
Hydraulic Drive Units:
16. Inspect the coupler between the hydraulic
drive and the drive roller, for wear.
- Top-end drive or on drive box.
17. Oil hydraulic drive coupler or chain.
Fig 40 - Top-end hydraulic drive