CONVEY-ALL 1635-FL, Руководство оператора

Страница: 44 / 60

4-10 08.2020
Operator’s Manual: 1600-FL Series Conveyor
Belt Alignment at Discharge Roller:
10. If necessary, remove the discharge spout to
view the roller.
Note:
If belt is out of alignment,
it will move to the loose side.
Tighten loose side or loosen tight side.
11. Adjust one side of roller at a time.
- Loosen the bearing housing, then adjust.
12. Tighten the discharge roller bearing housing.
13. Run the belt a couple of revolutions and
check the alignment.
- Repeat steps until the belt runs centred.
14. Replace the bearing housing guard.
Fig 51 - Inside discharge spout