CONVEY-ALL 1635-FL, Руководство оператора

Страница: 34 / 60

3-14 08.2020
Operator’s Manual: 1600-FL Series Conveyor
3.10 STORAGE
After the season’s use, or when the conveyor
will not be used for an extended period of time,
the conveyor should be thoroughly inspected
and prepared for storage.
Repair or replace any worn or damaged
components to prevent unnecessary down-time
next season.
For a long, trouble-free life, this procedure
should be followed when preparing the machine
for storage:
1. Remove all left over product or residue from
the hopper and inside tube.
2. Inspect all moving or rotating parts and
remove anything which has become
entangled.
3. Wash the entire machine thoroughly using a
water hose or pressure washer to remove all
dirt, mud, debris or residue.
- Wash on top and under the belt.
- Clean inside the tube.
4. Inspect all hydraulic hoses, fittings, lines,
couplers and valves.
- Tighten any loose fittings.
- Replace any hose that is badly cut, nicked
or abraded or is separating from the
crimped end of the fitting.
5. Lubricate all grease fittings.
Refer to Section 4.2
- Ensure all grease cavities have been filled
with grease to remove any water residue
from having been washing.
6. Check the condition of the conveyor belt.
Replace if necessary.
7. Remove the battery.
- Be sure it is fully charged.
- Store it inside.
- Do not sit the battery on a cold, concrete
floor.
Fig 30 - Collapsed position
8. Touch up all paint nicks and scratches to
prevent rusting.
9. Select an area that is dry, level and free of
debris.
If the machine cannot be placed inside,
cover the engine with a waterproof tarpaulin
and tie securely in place.
10. Do not allow children to play on or around
the conveyor.
IMPORTANT:
If conveyor has been stored for over 6 months,
run engine for 2-3 minutes. Then, change oil,
while still warm, to remove any condensation.