XW-210 WiFi™ Users Manual
Section 3: Provisioning
After making the sensor connections and providing power, you must provision the XW-210 for use on
your wireless network. The goal is to configure the XW-210 such that it can recognize and attach to your
Wi-Fi access point. There are two methods for doing this:
3.1
Access Point
By default, the XW-210 comes up as a wireless access point when powered for the first time. Pressing
the "access point" push button any time also activates the access point mode. It isn't really an access
point because it will not provide internet connectivity to your computer or smart phone, but it will appear
as an access point meaning that your computer or smart phone will detect it as an access point and
display it as such. When acting as an access point, the XW-210 broadcasts an SSID of “XW210-
XXXXXX” where XXXXXX are the last six digits of its MAC address.
With your wireless device (laptop computer or smart phone) scan for, and attach to the XW210 wireless
network. Next, access the web server in the XW-210 using a web browser. To access the setup pages,
enter the following URL in the address bar of your web browser:
http://192.168.1.2/setup.html
After the page is requested, a password prompt will appear. Enter the username and password. The
username is
admin
and the password is
webrelay
(password is case sensitive). The next chapter
explains each of the setup tabs and screens. Use the
WiFi Networks tab
for making the proper settings
to allow the XW-210 to connect to your access point.
Notes About Access Point Mode:
•
As an A
ccess Point
the XW-210 functions independently of other wireless networks. It
broadcasts beacons and services WiFi packet requests. In this mode, your computer or smart-
phone is connected directly with the XW-210 on a private network and is NOT using another
WiFi network. Typically you would use this for configuration and not for normal operation.
•
The XW-210 has no hardware “restore defaults” button, to prevent the installer from being locked
out, the default username (
admin
) and password
(webrelay
) always work in the access point
mode, even if the password is changed. If the password has changed via the
Password tab
, both
the new password and the
webrelay
password will work. Additionally, the IP address and HTTP
port will temporarily revert to the default values shown above when in the access point mode.
•
Only one client (computer or smart-phone) can be connected to XW-210 at a time.
•
SSID and password cannot be customized (once again this mode is intended for configuration
only).
•
Access point is unsecured and open.
Xytronix Research & Design, Inc.
Page 19
Содержание WebRelay Wireless XW-210I
Страница 1: ......
