32
EN
W415-1398 / C / 06.15.17
4.2
USING FLEXIBLE VENT COMPONENTS
For safe and proper operation of the appliance, follow the venting instructions
exactly.
All inner fl ex pipe and outer fl ex pipe joints may be sealed using high
temperature red RTV silicone W573-0002 (not supplied) or the high temperature
sealant W573-
Elbow
0007 Mill Pac (not supplied). However, the high temperature sealant W573-0007
Mill Pac (not supplied) must be used on the joint connecting the inner fl ex pipe
Spacers
and the exhaust fl ue collar.
Use only approved fl exible vent pipe kits marked:
“Wolf Steel Approved Venting” or “E2” as identifi ed by the stamp on the fl ex pipes.
22.1C
4.2.1 HORIZONTAL AIR TERMINAL
INSTALLATION
A.
Stretch the inner fl ex pipe to the required length
taking into account the additional length needed
for the fi nished wall surface. Apply a heavy
bead of the Mill Pac sealant (W573-0007) (not
supplied) to the inner sleeve of the air terminal.
Slip the ven
t pipe a minimum of 2” (50.8mm)
WARNING
DO NOT ALLOW THE INNER FLEX PIPE TO BUNCH UP ON HORIZONTAL OR VERTICAL RUNS AND
ELBOWS. KEEP IT PULLED TIGHT.
SPACERS ARE ATTACHED TO THE INNER FLEX PIPE AT PREDETERMINED INTERVALS TO
MAINTAIN AN EVEN AIR GAP TO THE OUTER FLEX PIPE. THIS GAP IS REQUIRED FOR SAFE
OPERATION. A SPACER IS REQUIRED
AT THE START, MIDDLE AND END OF EACH ELBOW TO ENSURE THIS GAP IS MAINTAINED.
THESE SPACERS MUST NOT BE REMOVED.
!
Содержание CB30NTR
