Conexant H08-15350, Справочное руководство

Страница: 26 / 120

Command Reference Manual
Conexant
1118
3-8
3.2.2.2 Q - Quiet Results Codes Control
The command enables or disables the sending of result codes to the DTE according to the parameter supplied. The
parameter value, if valid, is written to S14 bit 2.
Syntax
O[value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 Enables result codes to the DTE. (Default.)
1 Disables result codes to the DTE.
Result Codes
OK <value> = 0 or 1.
ERROR Otherwise.
3.2.2.3 V - Result Code Form
This command selects the sending of short-form or long-form result codes to the DTE.
Syntax
V[value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 Enables short-form (terse) result codes. Line feed is not issued before a short-form
result code.
1 Enables long-form (verbose) result codes. (Default.)
Result Codes
OK <value> = 0 or 1.
ERROR Otherwise.
3.2.2.4 W - Connect Message Control
This command, in conjunction with S95 bits 0, 2, 3, and 5 (bits 2, 3, and 5 can be written directly by the host or by the +MR,
+ER, and +DR commands, respectively), control the format of CONNECT messages (see Section 3.5 and Table 3-14). The
actual result code messages reported reflect the W command setting and the S95 bit settings. (Also see +MR, +ER, and +DR
commands.)
Syntax
W[value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 Upon connection, the modem reports only the DTE speed (e.g., CONNECT 19200).
Subsequent responses are disabled. (Default.)
1 Upon connection, the modem reports the line speed, the error correction protocol, and
the DTE speed, respectively. Subsequent responses are disabled.
2 Upon connection, the modem reports the DCE speed (e.g., CONNECT 14400).
Subsequent responses are disabled.
3 Upon connection, the modem reports DCE speed and the error correction protocol.
Result Codes
OK <value> = 0-3.
ERROR Otherwise.