Condux Gulfstream 350e, Руководство пользователя и инструкция по безопасности

Страница: 7 / 52

7
The use of the Gulfsteam™ 350e for operations that are different from those discussed in this manual are
considered potentially dangerous and thus not approved. The use of the Gulfstream™ 350e for purposes
other than the ones described in this manual will result in improper use and relieves the manufacturer
from any responsibility, civil or penal. The manufacturer’s responsibility declines even when one of the
following happens:
a. Unapproved or modifications carried out without the manufacturer’s written acceptance.
b. The use of inappropriate spare parts.
c. Inadequate maintenance.
d. Use with bypassed safety devices.
e. The connection of this machine to non-approved accessories or other devices.
Designed to reduce stress on the fiber optic cable during installation, The Gulfstream™ 350e is a unique
device intended for installing fiber optic cable directly into conduit with out the use of pull tape and pulling
machines.
Comprised of an air block and a tractor drive that, when combined with an air compressor , will propel
fiber optic cable measuring from 5/32" (4 mm) to 5/8" (16 mm) into an unobstructed, unoccupied, airtight
conduit run at speeds of 0 to 330 feet per minute (0-100 m/min). For Traditional Duct a cable carrier must
be placed at the front end of the cable. For Micro Duct cable tips may be used with micro fiber.
The Gulfstream™ 350e comes standard with case, digital counter, and common parts kit (Figure 2 and 3).
GENERAL MACHINE USE
a. Only qualified operators should use the machine. The operator should only be the person who
received qualified training from the product owning company or trained by the manufacturer.
b. Machine must only be used for the work it was designed for.
c. Machine is not to be used by unauthorized personnel in any application.
d. Should there be any doubt concerning use, maintenance or anything else, please contact the factory or
authorized Condux Supplier.
OPERATOR QUALIFICATIONS
a. Operator in charge of the machine and installation project must be appropriately dressed, avoiding
loose clothes, hanging jewelry or whatever might become entangled in the moving parts.
b. Operator must also wear the necessary protective equipment such as gloves, boots, and hard hat.
c. Operator must carefully follow all advisements contained in the instruction manual or on the machine.
d. Operator must have work area kept clean of obstacles that might inhibit a safeworking area.
e. Use only in areas of good lighting and environmental conditions.
MAINTENANCE QUALIFICATION
a. All of the machine maintenance must be carried out with the machine on a level surface and not
attached to any form of power source: electrical or pneumatic.
b. Only authorized and trained personnel must do all maintenance operations. Trained personnel
are defined as people who have received qualified training from the using company or from the
manufacturer.