Operating Instructions
750 W 27 V pickup
CQF 04/2 + Interface M12
BAL9100-0145a-EN
www.conductix.com
translated document
Page 39 of 40
14.2
Interface
Source: Phoenix contact
The cable for this interface, which comes from the device, can be ordered separately from
the following manufacturers. For details, please refer to the table or the manufacturer's
website.
Alternatively, a compact enable plug is available that allows the device to auto-start.
Enable plugs (set of 5) can be ordered from Conductix-Wampfler under the material
number 91000-400-3089971.
Please note that the enable plug does not allow external on/off switching, nor can it be
used for diagnostic purposes. For details, please refer to the product documentation.
Description
Conductix-Wampfler material number
Enable plug set
91000-400-3089971
Material number
“Phoenix contact”
Material number
“Binder connector”
http://www.binder-connector.de
5 m shielded cable
Pre-assembled 1 plug (customer side)
1407848
79 3579 3508
5 m unshielded cable
Pre-assembled 1 plug (customer side)
_
79 3479 3508
Plug with pre-terminated wire ends
1523492
09 3481 700 08
Plug with solder terminals
1542758
_
The following listing is for informational purposes. It refers to the 2012 manufacturer information and
applies only to the material specified in this section. If in doubt or if any other material should be used, it
is important to ensure that the pin number and color code match the line to avoid possible damage to
the connected equipment.
PIN 1
White
PIN 2
Brown
PIN 3
Green
PIN 4
Yellow
PIN 5
Gray
PIN 6
Pink
PIN 7
Blue
PIN 8
Red or shielded
