8
In the normal operating mode the operating and display unit is in the indication level. The indication
level forms a loop that includes several pages holding operating information which can be accessed
with the arrow keys. The various displays of the indication level are shown below.
Info page 1: Standard operating display
The appearance of the standard operating display (info page 1) depends on the actual operating status and
the configuration of the Condair GS/Condair GS...OC. The following displays are possible.
Menu
Condair GS 240
Demand :100%
Limiter : 70%
03.03.2009 12.00.00
Standard operating display when the unit is controlled via an
external
controller:
– Standby (no humidity demand) or Demand in % (humidity demand present)
– Supply air limitation in %rh *
* this parameter appears only if external supply air limitation is activated
Menu
Condair GS 240
Act.Humidity:75%
Hum.Setpoint:50%
Lim.Humidity:60%
Lim.Setpoint:80%
Standard operating display when the unit is controlled via the
internal
controller:
– Actual humidity in %rh
– Set nominal humidity %rh
– Actual humidity of supply air in %rh **
– Set supply air limitation in %rh **
** these parameters appear only if internal supply air limitation is activated
Info page 2: Control Settings
Menu
Condair GS 240
Software :1.00LA00
Controlsign.:0-10V
Limitsignal :0-10V
Modbus Addr.:1
– Software version (1.00)/language version (LA00)
– Set control signal range (signal Y)
– Set control signal range for the supply air limitation (signal Z). Appears only if
supply air limitation is activated.
– Set Modbus address of the unit
Info page 3: Performance data
Menu
Condair GS 240
Power Limit :100%
Sys. Request: 50%
Out./ Burner:40kg/h
Total Steam :120kg/h
– Set power limitation in %
– Actual steam capacity in % of the maximum steam capacity
– Actual steam capacity per burner in kg/h
– Actual steam capacity of the unit in kg/h
Info page 4: Burner data
Menu
Condair GS 240
Burners :6
Active :3
Lead Buner :1
Disabled :------
– Number of available (enabled) burners
– Number of currently active burners
– Number of the leading burner (this burner ignits first in the starting sequence
when the units starts next time the steam production)
– Shows the currently enabled (–) and disabled (X) burners (example: “-X-X--”
means burners 1,,5 and 6 are enabled, burners and 4 are disabled)
Info page 5: Maintenance settings
Menu
Condair GS 240
Service Int.:800h
Remaining :500h
Start Date :09.19.03
– Set maintenance interval time in h
– Time remaining until next maintenance in h
– Date the maintenance alarm has been reset last time by the user
3
Interrogation functions
3.1
Interrogation of the operating information in the indication level
