Comtech EF Data Radyne RCS20, Инструкция по установке и эксплуатации

Страница: 40 / 200

RCS20 M:N Redundancy Switch Revision 15
User Interfaces MN-RCS20 and CD-RCS20
4–8
2. Press <TOG MODE> to switch through the choices above.
3. Press <CLR> or <NEXT> to abort programming (no switch parameters changed).
4. Press <ENT> to load the information on the screen into the switch parameter table.
Key Label Function
S1

Press to move the blinking cursor to the left. Used to select the channel
connection.
S2

Press to move the blinking cursor to the left. Used to select the channel
connection.
S3
TOG
MODE
Used to toggle through the choices above. Multiple connections may be entered.
S4 NEXT Press to cycle to the next screen.
Numeric Keypad ---
Press <CLR> or <NEXT> to abort programming (no switch parameters changed).
Press <ENT> to load the information on the screen into the switch parameter table.
4.3.1.2 MODEM ADDRESSES
This screen allows the user to program the remote addresses of each modem connected to the
redundancy system. All addresses must be in the range of 32 to 255 decimal. All entries on this screen
are in decimal. Multiple addresses may be programmed.
4.3.1.2.1 Programming steps:
1. Press

or

to move the blinking cursor to the channel to be programmed.
2. Use the numeric keypad to enter the address for the channel at the cursor.
3. Enter an address for each modem connected to the redundancy system at the blinking cursor.
Addresses for channels that do not have a modem connected will be ignored.
4. Press <CLR> or <NEXT> to abort programming (no switch parameters changed).
5. Press <ENT> to load the information on the screen into the switch parameter table.
Key Label Function
S1

Press to move the blinking cursor to the left. Used to select the modem (labeled Modems
MODEM ADDRESSES USE KEYPAD
B2 B1
1 2 3 4 5 6 7 8 9 0
101 102 103 104 105 106 107 108 109 110
<--- ---> NEXT