Compool Cp3830, Инструкция по установке и эксплуатации

Страница: 24 / 45

22
Compool Cp3830
LXD) into Power Center.
There are two ways to configure the spa 2-Speed filter pump.
Automatic configuration.
The system will run the filter pump in “low speed” during normal operation, but will
automatically switch the pump to “high speed” for 5 minutes whenever the spa filter pump
turns on.
It is additionally possible to activate the pump in “high speed” whenever the SPA
HEATER, or AUX2 is turned on. To enable the pump to run in “high speed” during these
conditions, it is necessary to adjust the HI SPD program switch, which is located at bottom
of the Power Center circuit board.
Connect RLY-LXD relay control wire into SPA 2SPD relay socket.
Manual configuration.
The system will run the spa filter pump in “low speed” during normal filter operation, but
will switch the pump to “high speed” when the selected auxiliary circuit is activated.
Select an auxiliary circuit (AUX1 - AUX6), and connect RLY-LXD control wire into the
appropriate relay socket.
Two Speed Pool Filter Pump
If the system is equipped with a 2-speed pool filter pump, install a 2-speed relay kit (model
RLY-LXD) into Power Center.
There are two ways to configure the pool 2-Speed filter pump.
Automatic configuration.
The system will run the filter pump in “low speed” during normal operation, but will
automatically switch the pump to “high speed” for 5 minutes whenever the pool filter pump
turns on.
It is additionally possible to activate the pump in “high speed” whenever the POOL
HEATER, or AUX1 is turned on. To enable the pump to run in “high speed” during these
conditions, it is necessary to adjust the HI SPD program switch, which is located at bottom
of the Power Center circuit board.
Connect RLY-LXD relay control wire into POOL 2SPD relay socket.
Manual configuration.
The system will run the pool filter pump in “low speed” during normal filter operation, but
will switch the pump to “high speed” when the selected auxiliary circuit is activated.
Select an auxiliary circuit (AUX1 - AUX6), and connect RLY-LXD control wire into the
appropriate relay socket.
Telephone Module
The Telephone Module (model MOD-TELSPA) allows turning the spa on/off from a phone. If
preferred, the Telephone Module can be configured to turn on/off the pool heater instead. The
factory default is to control the spa.