6
Compool Cp3830
Plumbing Requirements
Plumb system in accordance with recommended hydraulic schematic.
1.
If a jet booster pump is being used, it is recommended that 1/4 HP per jet be installed. If a
single pump system is being used, it is recommended that 1/2 HP per jet be installed.
2.
If a Spa-side Remote is to be used, install a 3” to 6” length of 1.5” Sch. 40 pvc pipe in the
spa wall so that the Spa-side Remote will not be submerged. Positioning the top of the
pipe 1/2” below the coping. The pipe should extend beyond the finished surface and will
be cut back after tile work is completed. Connect a 1/2” conduit and run back to Power
Center. Use sweep elbows for turns.
3.
Plumb solar feed and return lines between the filter and heater. Install 3-port solar valve at
the feed line. Use Compool solar valve (model SOL-2T), to allow automatic draining of
panels.
4.
Glazed solar panels require a drain valve (model HW-5B) to allow draining of panels. This
prevents damage from overheating water. Install drain valve at solar feed line and connect
to the pool fill line.
5.
Plumb solar feed and return lines between the filter and heater. Install 3-port solar valve at
the feed line. Use Compool solar valve (model SOL-2T), to allow automatic draining of
SOLAR
SENSOR
CLEANER
PUMP
CVA-24
HEATER
CVA-24
SOLAR
PUMP
VACUUM
RELIEF
WATER
SENSOR
SKIMMER
FILTER
PUMP
FILTER
MAIN
DRAIN
HW
-5B
WATERFALL
POOL
LIGHT
POOL
7
3
8
5
FREEZE
SENSOR
CONTROL PANEL
POWER CENTER
SOLAR
SENSOR
HEATER
CVA-24
VACUUM
RELIEF
WATER
SENSOR
FILTER
PUMP
FILTER
JET
PUMP
SPA-SIDE
REMOTE
AIR
INTAKE
SPA
LIGHT
SPA
1
2
11
4
6
Содержание Cp3830
Страница 1: ...Compool Cp3830 POOL SPA CONTROL SYSTEM Installation Operating Instructions 05 01 98 941 1010...
Страница 2: ......
Страница 43: ...41 Compool Cp 3830...