Compool Cp3830, Инструкция по установке и эксплуатации

Страница: 28 / 45

26
Compool Cp3830
HI SPD - High Speed
High Speed settings are used to configure the following equipment.
SHEAT Activate high speed when spa heater is on.
AUX2 Activate high speed when AUX2 is on.
PHEAT Activate high speed when pool heater is on.
PAUX1 Activate high speed when AUX1 is on.
PHONE CONTROLS
Phone Controls settings are used to configure the following equipment.
POOL HEAT Activate pool Heat Source key.
SPA Activate Spa key.
System Start-up
• To perform initial start-up
1. At the Power Center, press the Auto/Service key to select Service mode.
2. Press Equipment keys (Spa Filter Pump, Pool Filter Pump, 1, 2, 3, 4, 5, and 6,) verify
equipment is being activated.
3. Press the Heater keys, verify heaters fire (Filter pumps must also be on).
4. Press the Solar keys, verify solar valves (if applicable) rotate to solar position. If either
valve is 180 degrees out of phase, flip the toggle switch on the rear of Valve Actuator to
reverse phase (ON1/ON2).
5. Check Sensor Status lights. If a light is on, check appropriate sensor wiring and
connections.
6. Press the Auto/Service key to select Auto mode.
7. At the Spa-side Remote, press the Red, Yellow, Green, and Blue key, verify equipment is
being activated. Verify the light in the middle of the remote turns on.
8. At the Control Panel, press Equipment keys (Spa, Pool, 1, 2, 3, 4, 5, and 6), verify
equipment is being activated.
9. Affix labels provided to identify Equipment keys at the Control Panel, Power Center, and
Spa-side Remote.
10. Calibrate sensors. See Calibration for details.
11. Program equipment as needed. See Programming for details.