Installation
3-23
Compaq Confidential – Need to Know Required
Writer: Everett Godaire Project: TL891 MiniLibrary System User's Guide Comments:
Part Number: ER-TL891-UA.A01 File Name: d-ch3 Installation Last Saved On: 3/2/99 2:30 PM
WARNING:
The cooling fan at the rear of the drive must not be obstructed
when the drive is installed in the rack. It is advisable to allow two inches of
clearance behind the rear panel of the module.
Make certain that when the Module is fully extended that a force of 20% of the
rack weight, but not more than 57 lb. applied in any direction but upwards does
not cause the rack to overbalance.
Metric Conversion Bracket Description and
Identification:
1.
Refer to Figure 3-12 to identify and take inventory of the metric
conversion hardware included in your metric rackmount kit.
2.
Determine where the module you are installing is going to be located
relative to the top module.
a.
If the module you are installing is going to be located on the top of
the stack or the second from the top (unit 1 or 2), the parts which you
will need to install this module are:
2 pieces
968312-101
4 pieces
968313-101
b.
If the module you are installing is going to be located third or fourth
from the top (unit 3 and 4), the parts which you will need to install
this module are:
2 pieces
968319-101
4 pieces
968320-101
c.
If the module you are installing is going to be located fifth or sixth
from the top (unit 5 and 6), the parts which you will need to install
this module are:
2 pieces
968608-101
4 pieces
968609-101
d.
Sort out the appropriate adapters for your application. The part
number is stamped in the middle of the part for identification.
3.
Next to each mounting hole in the bracket, numbers are stamped which
correspond to the module number. If you are installing the first module
for example, mount the flat head screws (P/N 213164-108) through the
holes marked #1.