IE-GPR-LP040-03
24
If the value to store is the same as the original already stored value, executing the command will
have no effect. In this case, the modem will only send back the same information as in the case of
Information about permitting of the alarm SMS messages
. So if only the information is sent back
though the user entered the setting command, it means the parameter is already set as required (it
wasn’t needed to change it).
5.2.10. Information about numbers for the alarm SMS messages
If the SMS message
alarms#
without any parameters is sent, the modem will send back the
SMS message with the list of all phone numbers for the warning SMS messages recipients.
The command
alarms#
The command for reading of information about phone numbers for
the alarm SMS messages.
An example of the response message
The list of the alarm phone numbers:
empty
The list of the phone numbers is
empty.
The list of the alarm phone numbers:
+420123456789, +420987654321
The list contains phone numbers
+420123456789, +420987654321.
5.2.11. Adding a number for the alarm SMS messages
This command is intended for adding the current sender’s phone number to the list of phone
numbers for the warning SMS message recipients. The list can contain up to 8 phone numbers.
The command
alarms# +
The command for adding a phone number for the alarm SMS
messages.
An example of the response message
The alarm phone 420123456789 was
added to the list
The sender’s phone number was added
to the list.
The alarm phone 420123456789 is
already contained in the list
The sender’s phone number was not
added to the list, because this
number already occurs in the list.
The list of the alarm phone numbers is
already full
The sender’s phone number was not
added to the list, the list is
already full.
An error occurred while accessing the
list of the alarm phone numbers
The error occured, adding the
sender’s phone number didn’t
succeed.
