Comet LP040, Инструкция по эксплуатации

Страница: 14 / 39

IE-GPR-LP040-03 14
4.4. Switching on the modem
The properly assembled modem is switched on by feeding of electric voltage into the
modem supply terminal block. The green LED diode lights up. The modem will be prepared for
communication after cca. 1 minute from its switching on. It is advisable to check the
communication by sending SMS message
gsmstatus to the modem phone number. A response
delivery time is generally dependent on a momentary cellular network load and state. If the modem
works correctly, it will send back SMS message with its state information. If you don’t receive the
response to this SMS message, please check your SIM card settings, power supply connection and
aerial connection.
If communication with the modem via cellular network is impossible, you can try to find a
problem with the program for data loggers. In this case, you must interconnect the modem and the
computer via the setting cable, see the chapter
The setting cable QMS2901 on page 8 .
4.5. Setting up the modem
If you don’t intend to use remote communication with the data logger via GPRS, you can go
to the chapter Setting of the other parameters on page 15 .
4.5.1. Setting of GPRS connection parameters
If you didn’t specify the GPRS connection parameters before ordering the modem, you must
set it up now.
To do it, you can send a special SMS message to the modem phone number. The first word
of the message must always be gprs . After this keyword, parameter values for an actual setting
follows in specific order (see below):
gprs [apn] [user] [password] [dns]
If the trailing parameter values are not entered, they will be deleted. Don’t enter the square
brackets in the SMS message. Individual items of the message must be separated by spaces. For
more detailed information about setting this parameter values via SMS command see the chapter
Setting of the GPRS connection on page 20 .
The example: You can set up the parameter apn to value internet without other parameters
( user , password and dns ) by sending the SMS message
gprs internet
For getting information about GPRS connection parameters please contact an appropriate
mobile operator.
4.5.2. Setting of M2MTalk client parameters
These parameters are already preset at the factory, don’t change it gratuitously! If you can
verify a setting, compare it with data listed in the card which was delivered with the modem.
M2MTalk client parameters can be set via the SMS command (see the chapter Setting of the
M2MTalk server connection on page 22 ) or via the setting cable (see the chapter Setting of the
modem using the setting cable on page 35 ).