42
EXTRAORDINARY MAINTENANCE
46. REPLACING THE FRONT SQUEEGEE RUBBER
Suction will be poor and the machine will not dry perfectly if the front squeegee rubber is worn. Proceed as
follows to replace:
1.
Ensure that the electrical system connector is disconnected from the battery connector
2.
Ensure that the main switch is in the “0” position
3.
Check the parking brake is engaged
4.
Disconnect the squeegee by loosening the knobs (1)
5.
Undo the rubber-pressing blade securing screws (2)
6.
Remove the rubber-pressing blade (3), then the rubber, for replacement
7.
To replace the rubber, proceed in reverse order
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions
47. REPLACING THE REAR SQUEEGEE RUBBER
If the squeegee rear rubber is worn and does not dry well, it is possible to change the drying edge using
one of the 4 edges of the rubber.
This can be done with the squeegee removed, proceeding as follows:
1.
Ensure that the electrical system connector is disconnected from the battery connector
2.
Ensure that the main switch is in the “0” position
3.
Check the parking brake is engaged
4.
Disconnect the squeegee by loosening the knobs (1)
5.
Rotate the fixing plates (2)
6.
Remove the rubber-pressing blade (3) and then the rubber, to turn it over or replace it
7.
To replace the rubber, proceed in reverse order
8.
Adjust the height of the squeegee depending on the rubber (see “ADJUSTING THE HEIGHT OF THE
SQUEEGEE SUPPORT”)
ATTENTION: These operations must be carried out using gloves to protect
against contact with dangerous solutions
48. REPLACING THE CENTRAL RUBBER OF THE BRUSH HEAD COVER SPLASH GUARD
If the splash guard central rubber in the brush head cover is worn and does not dry well, it is possible to
change the drying edge using one of the 4 edges of the rubber.
This operation can be done with the brush head cover removed, proceeding as follows:
1.
Ensure that the electrical system connector is disconnected from the battery connector
2.
Ensure that the main switch is in the “0” position
3.
Check the parking brake is engaged
1
3
2
1
2
3
1
