24
MACHINE PREPARATION
23. FILLING THE DETERGENT/SOLUTION TANK (VERSION WITH CDS)
Proceed as follows to fill the solution tank:
1.
Turn the main switch key anticlockwise to the "0" position
2.
Engage the parking brake
3.
Remove the filler cap (1) and check that the solution filter is fitted correctly
4.
Fill it with clean water at a temperature not exceeding 50
C.
It is possible to fill the tank without having to constantly watch the water level, using the optional rapid
filling system (2); this system is fitted with a float to control overflow. The water pipe (previously modified)
is inserted into the quick release coupling; remember to unscrew the cap (1) to allow proper air venting.
5.
Unscrew the cap (3) of the tank on the right-hand side of the machine and fill with liquid detergent as
indicated on the label supplied with the machine. Make sure you properly close the screw cap to
avoid liquid leakage during the operation; also check that the quick release coupling (4) under the
detergent tank is properly fitted.
To regulate the water/detergent mixture, carefully read the “REGULATING THE DETERGENT WITH THE
CDS SYSTEM” paragraph.
ATTENTION: The DS automatic dosing system is designed to work with any
liquid detergent. For this reason, the percentage of detergent in the solution is
subject to a maximum error of 5% compared with the nominal value selected.
WARNING: The dosing system is suitable for frequent maintenance cleaning.
Acid or alkaline maintenance detergent tank be used with pH values between 4
and 10 and that do not contain: oxidising agents, chlorine or bromine,
formaldehyde, mineral solvents.
The detergents used must be suitable for use with scrubbing machines.
Wash the circuit with water after use if the system is not used daily. The system
is excludable. In case of sporadic use of detergents with pH between 1-3 or 11-
14, use the scrubbing machine in the traditional way by adding the detergent in
the clean water tank and excluding the dosing circuit.
ATTENTION: always use detergents whose manufacturer's label indicates
their suitability for scrubbing machines. Do not use acid or alkaline products or
solvents without this indication.
In addition, you are advised to always use low foam detergents.
Do not use pure acids or detergents with a stronger gradation than that
indicated on the label supplied.
ATTENTION: Protective gloves should always be worn before handling
detergents or acidic or alkaline solutions to avoid serious injury to hands.
1
2
3
4
