34
AT THE END OF WORK
13.
Remove the suction hose (11) from the sleeve on the right-hand cover of the brush head unit
14.
Remove the right-hand cover of the brush head unit by extracting the split pins (12)
15.
Clean the brush head cover and the rubbers thoroughly with a jet of water
16.
After cleaning the brush head cover and rubbers, replace the cover on the brush head unit, first
inserting the front pin (13) in the front slot on the casing, then the rear pin in the rear slot, then insert
the split pins (12) previously removed.
17.
Finally insert the suction hose (11) in its sleeve
WARNING: this operation must be carried out by using gloves in order to
protect against contact with dangerous solutions
ATTENTION: Repeat the operations from number 14 to number 18 for the left-
hand side cover
18.
Raise the seat support plate and connect the electrical system connector to the battery connector
19.
Sit on the driver’s seat
20.
Insert the key in the ignition switch and turn it a quarter turn clockwise (to position "1")
21.
Disengage the parking brake
22.
Park the machine in a closed place, in an area where it cannot cause damage to people or other
property, but also be protected from an accidental fall of objects.
23.
Engage the parking brake
24.
Turn the ignition key a quarter turn anticlockwise (position "0") and remove the key
25.
Raise the seat support plate and disconnect the electrical system connector from the battery
connector
ATTENTION: do not leave the machine unattended without first removing the
start-up switch key and applying the parking brake. In addition, do not park the
machine in open places or on sloping floors
11
13
12
