38
Chapter 6: Ordering Paper and Supplies
A776II Two-Color Thermal/Impact Hybrid Printer: User Guide
A776 2UG0001 B 11/2016
Forms specifications
The A776II prints on single or multiple part forms in the slip station (up to four-part forms). Forms and slips must meet
the following requirements:
•
Front insertion (minimum)
51 mm (2 inches) wide
68 mm (2.68 inches) long
•
Side insertion (minimum)
51 mm (2 inches) wide
203 mm (8 inches) long
•
Single-ply forms should be on paper that is greater than 15 pounds
•
Multiple-part forms (up to four parts) should be no thicker than 0.40 mm (0.014”) and a minimum thickness of
0.08 mm (0.003”).
CAUTION
Do not use forms containing holes along the top or right edge.
•
Forms for use with flip check
(minimum) 70 mm (2.75 inch) wide
152 mm (6 inch) long
•
The slip form should be flat and
without curls or wrinkles, especially
at the top.
•
Considerations for glued edges on
slip paper:
a. No glue on bottom edge.
b. Right or top edge: Paper
feeding and insertion are
affected by gluing method,
length of edge, and quality of
glue used.
c. Left edge or wide slip paper:
Skewing may occur.
The Slip sensors that activate the slip-in light use a reflective photo sensor.
•
Do not use paper that has holes or dark areas with low reflection (less than 60% reflection) at the slip sensor
location. (Area “A” in the illustration above.)
•
Thin paper should be used between the top and bottom sheets of multi-part paper. Thick paper reduces the copy
capability.
•
For best print quality on the bottom sheets of multipart forms, use the double-strike mode.
•
If any part in a multipart form exceeds .003 inches in thickness, the remaining parts may be unreadable.
Paper feed
direction
Paper holes and
low reflection
prohibited areas
Slip edge
6 mm
(0.236")
A
A776 Slip Form Recom.eps
Содержание A776II
Страница 45: ......
Страница 46: ...A776 2UG0001 B 11 2016 ...
