Appendix B: Command reference
98-169085-B
AT commands
133
Context management AT commands
The table below summarizes some of the most used AT commands for context management.
Parameters are explained in the table in the next section. For details, refer to the 3GPP standard
TS 27.007.
Command Parameters
+CGACT
[<state>[,<cid>[,<cid>[,...]]]
+CGDCONT
[<cid>[,IP[,<APN>[,<PDP_addr>[,<d_comp>[,<h_comp>[,<apn
uname>,<apn_passwd>]]]]]]]
+CGDSCONT [<cid>,<p_cid>[,<d_comp>[,<h_comp>]]]
+CGEQMIN
[<cid>[,<Traffic class>[,<Maximum bitrate UL>[,<Maximum bitrate DL>[,<Guaranteed
bitrate UL>[,<Guaranteed bitrate DL>[,<Delivery order>[,<Maximum SDU size>[,<SDU
error ratio>[,<Residual bit error ratio>[,<Delivery of erroneous SDUs>[,<Transfer
delay>[,<Traffic handling priority>]]]]]]]]]]]]]
+CGEQREQ
[<cid>[,<Traffic class>[,<Maximum bitrate UL>[,<Maximum bitrate DL>[,<Guaranteed
bitrate UL>[,<Guaranteed bitrate DL>[,<Delivery order>[,<Maximum SDU size>[,<SDU
error ratio>[,<Residual bit error ratio>[,<Delivery of erroneous SDUs>[,<Transfer
delay>[,<Traffic handling priority>]]]]]]]]]]]]]
+CGPADDR
[<cid>[,<cid>[,...]]]
+CGTFT
[<cid>[,<packet filter identifier>,<evaluation precedence index>[,<source address and
subnet mask>[,<protocol number (ipv4) / next header (ipv6)>[,<destination port
range>[,<source port range>[,<ipsec security parameter index (spi)>[,<type of service
(tos) (ipv4) and mask / traffic class (ipv6) and mask>[,<flow label (ipv6)>]]]]]]]]]
