Chapter 5: Configuration with web interface
98-169085-B
Advanced settings
91
2. Select how many minutes with no activity before the terminal should enter power save
state (Idle time before power save).
3. Select
Prevent power save if satellite connection is active
if you do not want the
terminal to enter power save state while a data connection (PDP context) is opened on the
satellite connection.
4. Under
Daily wake up
, select
Enable
and enter the
Wake up time of day
if you want
the terminal to “wake up” from power save state at a specific time every day.
5. Under
Wake-on-LAN
, select
Enable
if you want the terminal to wake up from power save
when the LAN port receives a magic packet from locally connected equipment.
6. Under
Power control pin
, select
Enable wake up when activated
if you want to use
the power control signal (e.g. connected to the ignition of your vehicle) to wake up the
terminal from power save state.
Set the polarity (Active high/Active low) for the power control pin.
7. Click
Save
.
Important
When you select Idle power save mode you must enable minimum one
wake-up method (Daily wake up, Wake-on-LAN and/or Power control pin).
Note
With this option selected, the terminal will not enter power save state if there is a
PDP context open, even if it is not currently used to send or receive data.
Note
Local time must be converted to UTC time!
Note
With this option selected the terminal will be active when the Power control pin is
active.
