Chapter 4: To use the EXPLORER 323
98-169085-B
Power mode functions
36
General power save settings:
• Idle time - Set the number of minutes without any activity before the terminal enters power
save state.
• Set whether or not the power save function should be prevented when a satellite
connection (PDP context) is open (only configurable with web interface).
You can configure the wake up methods and the general power save settings in the web
interface under
Advanced
>
Power control.
See
For configuration with AT commands, see the section
To set up power save functions with AT
Power control pin function when Idle power save is selected
When you have selected Idle power save you can choose to enable the Power control pin in
the web interface.
Disabled:
If the Power control pin is disabled, the state of the pin is ignored.
Enabled
: If the Power control pin is enabled, the function is as follows:
You can set the polarity of the Power control pin, that is whether the pin should be active high
or low.
Default is active low
.
The function of the enabled Power control pin in Idle power save mode is:
Power control pin is active:
The terminal is on and will stay on as long as the pin is active.
Power control pin is inactive:
The terminal will go into power save state when the Idle time
has expired and none of the configured wake-up methods are active. See also the note in the
previous page)
