Club Car Precedent Villager 2, Руководство по техническому обслуживанию и ремонту

Страница: 364 / 414

23
Drive Clutch GASOLINE VEHICLE - CLUTCHES
WARNING
position. Use approved jack stands of proper weight capacity to support the vehicle and chock
the wheels that remain on the floor. When not performing a test or service procedure that requires
movement of the wheels, lock the brakes.
4. Remove the drive clutch retaining bolt (1) and mounting washers (2 and 3) (Figure 23-3, Page 23-4) . See
also Figure 23-4, Page 23-5. See following NOTE.
NOTE: On Subaru EX40 engines, the drive clutch mounting bolt has right-hand threads.
4.1. Use the drive clutch holder tool (1) while tightening or loosening the drive clutch retaining bolt (2) (Figure
23-4, Page 23-5) .
4.2. Hook drive clutch holder tool (1) on boss (3) of pulley located behind drive clutch and push against the
adjacent boss with holder.
5. Lubricate the threaded portion of the clutch puller tool (1) with a light oil and thread the clutch puller tool into the
female thread of the drive clutch
(Figure 23-5, Page 23-5) .
6. Support the drive clutch with your hand and use a 1/2-in. drive air wrench to tighten the clutch puller tool. The tool
will bottom out in the crankshaft and force the drive clutch (2) free of the crankshaft.
7. Remove clutch puller tool from drive clutch.
CAUTION
• Do not hit or tap the clutch with a hammer. Do not pry the clutch. These actions will damage the clutch.
DRIVE CLUTCH CLEANING AND INSPECTION
1. Use a dry, lint-free cloth to clean clutch parts.
CAUTION
• Do not lubricate the drive clutch. Lubricants attract dirt and dust, which interfere with proper clutch
operation.
• Use only a dry cloth to lightly wipe the shaft of the fixed sheave (18) (Figure 23-3, Page 23-4). Do not
use a brush or steel wool. These will damage the surface of the shaft.
• Do not use solvents. Solvents will damage the lubricating characteristics of the bushings.
2. Inspect the belt contact surfaces of the clutch sheaves for wear. If any area of a sheave contact surface has wear
of 0.060 in. (1.52 mm) or more, the clutch should be replaced.
DRIVE CLUTCH DISASSEMBLY
CAUTION
• The drive clutch is balanced as an assembly. Before disassembly, make match marks on the drive
clutch hub and on the moveable sheave so they can be reassembled in the same positions (Figure
23-6, Page 23-7).
1. Make match marks on the drive clutch hub and on the moveable face (Figure 23-6, Page 23-7) .
2. Remove the drive clutch hub (5) (Figure 23-3, Page 23-4) :
Page 23-6 2019 Precedent Villager 2 Maintenance and Service Manual