Club Car Precedent Villager 2, Руководство по техническому обслуживанию и ремонту

Страница: 49 / 414

ACCELERATOR AND BRAKE PEDAL GROUP Pedal Group – Electric Vehicle
5
MCOR
The pedal group for the Villager 2 electric vehicle includes a Motor Controller Output Regulator (MCOR) mounted on
the side of the pedal group. The MCOR detects the position of the GO pedal and sends a corresponding voltage to the
motor controller.
For more information see the following procedures:
• Test Procedure 11 – MCOR Voltage on page 12-22
• Test Procedure 5 – Key Switch and MCOR Limit Switch Circuit on page 12-16
• MCOR Removal on page 13-7
• MCOR Installation on page 13-7
PEDAL GROUP INSTALLATION
1. Connect the wire harness (12) to the MCOR (13) (Figure 5-2, Page 5-2) .
2. Position the pedal group in vehicle and secure with two screws (2) on the driver side and two screws (1) on the
passenger side. Tighten driver side screws (2) to 97 in·lb (11 N·m). Tighten passenger side screws (1) to
18 in·lb (2 N·m).
3. Remove the turnbuckle (6) and apply Loctite ® 242 to the threaded ends of both the rod from the pedal group (8)
and the brake actuator rod (9). Connect the rods using the turnbuckle (6).
4. Adjust the brake cable equalizer tension. See Brake Cable Equalizer Adjustment on page 6-8.
5. Place floor cover plate (7) over the floor opening and secure with fastener (10) (Figure 5-2, Page 5-2) .
6. Install the floor mat (2) over the pedal group. Make sure tabs on floor mat sides are beneath the sill (3). Tighten
screws (1) to 53 in·lb (6 N·m)
(Figure 5-1, Page 5-1) .
7. Connect batteries. See Connecting the Batteries – Electric Vehicles, Section 1, Page 1-4.
2019 Precedent Villager 2 Maintenance and Service Manual Page 5-3