Club Car Precedent Villager 2, Руководство по техническому обслуживанию и ремонту

Страница: 352 / 414

21
Fuel Tank GASOLINE VEHICLE - FUEL SYSTEM
WARNING
• Fuel may be under pressure. Use extreme caution when disconnecting fuel line to prevent the spray of
fuel onto hot engine. See Relieving Fuel Pressure on page 21-4.
• Carefully drain any fuel remaining in the hose or pump module into an approved container. Add
drained fuel back into fuel tank or dispose of properly.
9. Disconnect fuel pump module ground wire (7).
10. Remove screws (9) holding the forward end of the fuel tank retainer (4). Lift up on the forward end of the retainer
(4) and unhook the rear end from the fuel bucket.
11. If equipped, remove retention tube (16) from between fuel tank (10) and fuel bucket.
12. Lift the fuel tank (10) from vehicle.
FUEL TANK DISPOSAL
1. Remove gas cap and fuel pump module from tank. See Fuel Pump Module Removal on page 21-20. The
cap may be discarded or kept as a spare.
2. In a well-ventilated area, flush the fuel tank with water to remove any remaining fuel.
3. In a well-ventilated area, set the tank upside down so that the water can drain out of it. To make sure that the tank
dries completely, allow the tank to sit for 24 hours.
See following CAUTION.
CAUTION
• Dispose of wastewater and fuel tank in accordance with local, state, and federal laws and ordinances.
FUEL TANK STORAGE
1. Remove gas cap and fuel pump module from tank. See Fuel Pump Module Removal on page 21-20.
2. In a well-ventilated area, flush the fuel tank with water to remove any remaining fuel.
3. In a well-ventilated area, set the tank upside down so that the water can drain out of it. To make sure that the tank
dries completely, allow the tank to sit for 24 hours.
4. Completely drain gas from fuel pump module and allow to module to dry.
5. After module is completely dry, install in fuel tank. See Fuel Pump Module Installation on page 21-20.
6. Store the tank upside down, with the cap installed, in a well-ventilated area.
FUEL TANK INSTALLATION
NOTE: This gasoline vehicle complies with the California Air Resources Board (CARB) and EPA evaporative
emissions regulations when equipped with SAEJ30R9 1/4 in (6.3 mm) fuel vent hose and 3/16 in (4.78 mm)
fuel vent hose. To remain in compliance with California and EPA regulations, replace any fuel vent hose on
this vehicle with Club Car fuel vent hoses or equivalent.
1. Place fuel tank (10) in vehicle.
2. Insert retention tube (16) between fuel tank (10) and fuel bucket.
3. Secure tank with retainer (4).
3.1. Insert the tabs on the rear of the retainer (4) into the slots on the back of the fuel bucket (Figure 21-15,
Page 21-22) .
3.2. Pivot retainer (4) to place the front edge over mounting holes. Install screws (9) to secure the retainer.
Tighten screws to 31 in·lb (3.5 N·m).
Page 21-24 2019 Precedent Villager 2 Maintenance and Service Manual