Club Car Precedent Villager 2, Руководство по техническому обслуживанию и ремонту

Страница: 162 / 414

12
Test Procedures
ELECTRIC VEHICLE - EXCEL SYSTEM
TROUBLESHOOTING
1. If necessary, see Testing Basics on page 12-11.
2. Disconnect the batteries and discharge the controller. See Disconnecting the Batteries – Electric Vehicles
on page 1-4.
3. Remove the instrument panel. See Key Switch Removal, Section 13, Page 13-1.
4. Disconnect the orange/white and pink wires from the reverse buzzer.
5. Place the Tow/Run switch in the TOW position and connect the batteries. See Connecting the Batteries –
Electric Vehicles on page 1-4.
6. Place the key switch in the OFF position and the Tow/Run switch in the RUN position.
7. Using a multimeter set to 200 volts DC, place the black (–) probe on battery no. 6 (6 x 8-Volt battery set) negative
post and place the red (+) probe on the pink wire terminal end that was disconnected from the reverse buzzer.
The reading should be approximately 48 volts (full battery voltage).
7.1. If the voltage reading is correct, proceed to step 7.
7.2. If reading is zero volts, check wire continuity, 9-pin connector, 15-amp fuse and Tow/Run switch. See Test
Procedure 3 – Tow/Run Switch on page 12-14.
7.3. If the continuity readings are not correct, repair or replace the pink wire.
7.4. If the continuity readings are correct, proceed to step 7.
8. Place the Forward/Reverse switch in REVERSE. Using a multimeter set to 200 volts DC, place the black (–)
probe on the orange/white wire terminal end (that was disconnected from the reverse buzzer) and place the red
(+) probe on battery no. 1 positive post. The reading should be approximately 48 volts (full battery voltage).
8.1. If the voltage reading is correct, replace the reverse buzzer.
8.2. If reading is zero volts, check orange/white wire continuity and connection at Pin 7 in 16-Pin connector.
8.3. If there is no continuity in the orange/white wire, or the pin 7 terminal in the 16-pin connector is not properly
seated, repair or replace as required.
8.4. If the orange/white wire continuity and 16-Pin connector are correct and there is no voltage at the orange
wire, replace the controller.
TEST PROCEDURE 17 – Charge Indicator Light
See General Warnings on page 1-2.
1. With batteries connected, Tow/Run switch in the RUN position and the key switch in the OFF position, connect
charger DC cord to vehicle.
2. In a few seconds, the light will flash three times and the reverse buzzer simultaneously will sound three times to
indicate charging has begun.
See following NOTE.
NOTE: The number of flashes and beeps can vary depending on the Beep Option setting. See Beep Option,
Section 11, Page 11-8.
3. If charge indicator light does not flash three times, disconnect charger DC cord from vehicle and connect an
CDT to the vehicle.
4. Access the Monitor menu and select LED Driver by using the SCROLL DISPLAY buttons. The CDT should
indicate OFF.
5. Reconnect charger DC cord to vehicle.
6. In a few seconds, the CDT should quickly display ON just once while the dash-mounted charge indicator light
flashes three times.
See following NOTE.
NOTE: The CDT will still flash ON even with a failed or missing charge indicator light.
7. If the CDT quickly displays ON but the charge indicator light still does not flash, check the following items:
– Condition of the blue/yellow wire terminal in the 16-pin connector.
Page 12-30 2019 Precedent Villager 2 Maintenance and Service Manual