Club Car Precedent Villager 2, Руководство по техническому обслуживанию и ремонту

Страница: 56 / 414

6
Brake Shoe Removal WHEEL BRAKE ASSEMBLIES
2
3
4
1
5
2
3
1
636
Figure 6-1 Loosen Turnbuckle
1400-18100-10220
Figure 6-2 Shoe Retainer Pins
7. Remove brake drums and badly worn brake shoes.
7.1. On the back of each brake cluster assembly, locate the heads of two brake shoe retainer pins. It may be
necessary to remove sealant material around the head of each pin.
7.2. Insert a 1/2 inch x 5/8 inch cold chisel (1) under the head (2) of each pin and shear them off as illustrated
(Figure 6-2, Page 6-2) . This will release the shoes from the backing plate, allowing them to pivot away
from the inside of the brake drum (3), which should then allow the brake drum to be pulled free. After
completing step 8, skip step 9.
NOTE: Although step 8 allows easier access to the brake shoes, it is not imperative to do so in order to remove
the brake shoes.
8. For electric vehicles: Remove the axle shaft.
For gasoline vehicles: Remove the wheel hub assembly. See Rear Hub Removal, Section 24, Page 24-4.
9. Using needle nose pliers, turn the clip retainer pin (1) 90° to remove the shoe retainer clip (2) (Figure 6-3,
Page 6-3) .
CAUTION
• The brake shoes are under pressure and can release suddenly when brake shoe retainers are removed.
10. Grasp both brake shoes and pull them, together with the springs, out of the brake assembly as shown (Figure
6-4, Page 6-3) .
11. Remove adjuster wheel (1) with two washers (2 and 3) from the backing plate (Figure 6-5, Page 6-3) .
Page 6-2 2019 Precedent Villager 2 Maintenance and Service Manual